Third generation Tri-Logic3 keeps the same neutral characteristic as the Tri-Logic1 and 2, minimizing the coloring of tone, but also has an abundant of added features and flexibility to correspond with any bass guitar.
Gain control has an option between clean boost mode (Normal), with a maximum of +18db, or high gain mode (Hi Gain) with compression at +26db.
The Treble control provides ±15db and can be switched between 4KHz (low) or 8KHz (high) with toggle switch.
The Mid control knob provides ±10db and allows for sweeping between 250Hz to 3KHz.
The Bass control provides ±15db, switchable between 40Hz (low) and 80Hz (high), and allows you to obtain accurate and flexible sound in any playing environment.
Internal dip switch
Dip Switch (1)
Internal Dip Switch1 ‒ Input level can be switched to match Under normal circumstances, “Norm” (--> right position) setting should cause no unwanted distortion. However, if you are connecting to an instrument with active pickups, bigger output and dislike distortion, choosing the “Pad”(<-- left postition) setting can soften this distortion. Factory setting is “Normal”.
Dip Switch (2)
Internal Dip Switch2 ‒ Operating voltage option is 9VDC or 18VDC. Compared to 9VDC, 18VDC has less distortion with wider range of tone, but please be aware at 18VDC battery will drain faster. Factory setting is 18VDC. (18V left - 9V right)
Operating voltage option is 9VDC or 18VDC. Compared to 9VDC, 18VDC has less distortion with wider range of tone, but please be aware at 18VDC battery will drain faster. Factory Setting is 18VDC
Either 9VDC battery or 9VDC power adapter can be used.
*Please only use the regulated negative tip 9VDC power adapter.
*Please do not use other adapter except for a 9VDC negative tip power source to limit possibility of failure.
Relatively loud popping noise may occur when you use the foot switch for ON/OFF or change the mode using each mode switch shortly after turning the power on, or shortly after switching between 9VDC and 18VDC. This is not a device failure. Repeating the ON/OFF with foot switch to stabilize the operating voltage can reduce the popping noise
True Bypass Switching
Power Consumption: 9VDC / 3.3mA, 18VDC / 6.6mA.
Battery Type: 9VDC(006P)×1
AC Adapter: 9VDC, Negative Center Tip (Regulated Recommended)