This pedals is now offered as lower priced pcb-model or hand wired pedal.Both share the same specs and tone.
- Deep Blue Delay (DBD) is a natural sounding digital/analog delay, with analog direct signal path. The DBD has about the same bandwidth as the classic tape echo units, and it can be used in front of an amplifier or in amplifier effects loops.
- There are no noise reduction circuits, which keeps decay of echo as natural as possible.
- The direct signal path is short and made with analog amplifiers with no filtering.
- There should be no distortion or tone coloration as long as input level is in range below maximum allowed.
- The echo signal has a tuned filtering to allow extreme settings without interference.
- The delay is specially designed to work well with distorted tone, as this is the most critical application, where delays often fail.
- You can use the pedal before or after distortion. As such, it will work exceptionally well on clean sounds where requirements are less stringent, especially in terms of echo bandwidth and repeat formation.
- The delay tone has been carefully tuned with lot of attention to the first critical reflection and how the repeats decay.
Deep Blue Delay is kept small (Width x Length x Height :69mm x 111mm x 50mm including jacks and knobs) containing just the basic delay features; Delay Time, Delay Level and Repeat controls. It was designed to work as an ambience delay; like that of a vintage tape echo and the repeat formation was specifically designed to allow easy setting and less critical setting of delay time. With delay times higher than 120ms, the delay time is sometimes set on the beat or on a multiple of the beat. Deep blue handles this by not giving full range repeats, but a tuned response that donﾒt need to be on the beat to sound good.
- Current consumption: 25 to 32 mA depending on delay setting
- Voltage range: 8V to 15V (below 7,5 V delay signal will be muted)
- Input impedance IZ: 180K Ohm's
- Output drive capability: 10K Ohms
- Maximum input voltage: 2V peak 650mV rms
- Signal to noise ratio: 80dB
- Delay time: approximately 25mS to 450mS
- Power requirement: supplied via 2,1 mm standard jack
- Input and output connections: via 1/4" Switchcraft
- Complete bypass and input of circuit: grounded when in bypass