The Suhr SH-100 was designed in collaboration with Jazz Fusion/Blues guitarist Scott Henderson. This 100-watt, all-tube, hand wired amplifier features four EL-34s, a ’67 spec “Plexi” output transformer and a tube-buffered effects loop, to produce a broad range of warm, punchy cleans and thick modified high gain overdrive tones.
Power Select Switch Offers the following three-positions:
- OFF: Amplifier's power mains are switched off
- ON: On, normal operation
- Standby / Standback: With the power switch in the OFF position and the Standby switch in the Standby position, flip the power switch to ON. Wait sixty seconds, then flip the Standby switch to the Stand Back position. This will prolong tube life. To power down, simply switch the amplifier from Stand Back to Standby, then power switch to the OFF position.
Adjusts the amount of high frequencies. Turning it clockwise will add more cut and sparkle.
Adjusts the amount of low end. Turning it clockwise increases the amount of low frequencies, giving you a fuller tone. Turning it counter clockwise will reduce the effect and tighten up the bottom-end, useful when performing at louder volumes.
Adjusts the midrange. Turning it clockwise increases the amount of mids, giving your tone a fatter response. Turning it counter clockwise will produce a mid-scooped sound.
Adjusts the top end. Turning it clockwise increases the amount of treble, giving your tone clarity and brightness. Turning it counter clockwise will produce a warmer sound, excellent for dialing in smooth fluid-like lead tones.
Adjusts the amount of pre-amp gain, lower settings offer clean sounds - higher settings for crunch and hi-gain sustain.
Tubes: The SH-100 tube compliment consists of four EL-34 power tubes and three12AX7 preamp tubes.
Speaker Outputs: Two loudspeaker outputs wired in parallel with 3-way impedance selector switch for 4Ω, 8Ω & 16Ω.
- Output: 100 Watts RMS
- Tubes: 4-EL34 & 3-12AX7
- Front Panel: Power Select Switch, Presence, Bass, Middle, Treble, Gain controls and 1-Input
- Back Panel: Effects Loop: Send, Return, Return Level and Bypass/Active switch, 2-Speaker outputs, Impedance selector (4Ω, 8Ω, & 16Ω), 1/4 Fuse w/LED, 2/3 Fuse w/LED, Mains Fuse and Mains Inlet